Hard drives are really cool, except for all of the heat they create. They are what is used as permanent storage in the vast majority of personal computers sold today and throughout the last 50 years. IBM created the first hard drive in the 1950s and the evolution of the storage medium has been interesting to say the least. Why? The same principles are used and the general engineering is in some ways very similar; but the amount of storage has increased, and the physical size of the storage device has decreased, both by several orders or magnitude.
Here is a video I would recommend that does a great job of explaining the technology. While I do recommend this video, be warned that there are a few parts that some may consider too boring or too detailed.
The newest hard drives available in the consumer market (think home desktops, not the IT data center you would see at a large business) are available with up to 10 Terabytes (10,000 Gigabytes) in that same physical package and size you saw in that video. I didn’t see the specific model of the hard drive in that video, but it was likely a model that offered between 60 and 320 GB of storage capacity.
Here is a video (beware: no one has ever thought IBM of the 1950s or 1960s was “exciting” and this video created by IBM to show the development process of the first IBM hard drive) that goes over a lot of detail about the creation of the hard drive.
I know it isn’t as exciting as the latest Star Wars movie…..or any of the Star Wars movies, but I hope this little bit of information proved to be somewhat informative.
All modern computers (PC, Mac, desktop, laptop, tablet, smartphone, video game system, etc.) have many parts in common. They all have a power source and distribution system, motherboard/logic board, processor, temporary memory (RAM), permanent memory/storage (hard drive or solid state drive), video/graphics processor, and likely a display/monitor. For this post, you can assume that I am talking about a desktop computer unless otherwise stated. Also, this is meant to be a general description of each of these components. I will be writing more detailed posts about most of these components in the future.
Power System: You plug a power cable into the wall and it goes into the computer. What happens from there? In every computer system you run across, there will be a power supply unit (PSU).
This is a power supply from a Dell workstation.
The PSU takes the power supplied from the electrical system in your home or business and converts it to the appropriate voltage and wattage required by the various components in your computer. The largest of the cables coming from the PSU connects to the motherboard and provides power to all of the components embedded in, or connected to the motherboard. In recent years, some components that connect to the motherboard (processors, video cards) have become so powerful they need additional power beyond what is available in the 20 or 24 pin connector from the PSU and there will be additional cables/plugs available to power these components.
Motherboard/Logic Board:
This picture below is from www.trustedreviews.com – and shows a motherboard from 2006. The vast majority of the technology in this motherboard has been upgraded or replaced in that time, but the look and feel of motherboards has not changed all that much in the last 10-15 years.
What does a motherboard do? Every component of the computer touches the motherboard. The power supply connects via either 20, 24 or 28 pins in one or two locations (on this motherboard, you see a white connector along the bottom that has two rows of 12 pins). The memory is inserted into the slots just above the power connection. The processor sits in the square socket surrounded by a metal retaining clip to ensure it is firmly seated in the socket at all times. This particular motherboard, and many others, has a set of cooling pipes and heatsinks (all in copper) to distribute heat without the need for cooling fans. There are ports (orange, purple and green) in the lower left corner to connect hard drives, solid state drives, cd/dvd/bluray drives. In the upper left corner of this motherboard you will see different slots to connect video cards, sound cards, network cards, PhysX cards (not very common), etc.
The motherboard is the interstate highway system of your computer. It connects all of the components to each other through various data connections called buses.
Processor/CPU:
The processor handles all of the computational tasks inside your computer. When you boot your computer, the processor is involved in loading the operating system into memory(RAM), load device drivers, creating the graphical user interface, everything. Everything goes through the processor before you can begin to use each piece of software.
This image is from www.anandtech.com and shows one of Intel’s highest performing consumer processors from a few years ago.
High performance cpu from Intel for desktop computers.
Memory/RAM:
RAM (Random Access Memory) is where your computing environment lives. What do I mean by that? You push the power button, your computer begins to boot up. Your Operating System (Windows, Mac OS, Linux, iOS, Android, etc.) initializes and building the environment you will see on your screen and the services that run in the background that you don’t even think about (your desktop background picture, screen saver, antivirus, sound, and the services that allow you to interact with the computer or mobile device like the keyboard, mouse, touchscreen interface, etc.).
Now you have your computer up and running and you are able to launch a program; perhaps an email client or web browser, a photo editor, calendar, etc. Each program you have running moves into RAM and occupies storage space there. Your computer or mobile device has a finite amount of RAM and will eventually run out of space for programs, background services, widgets, etc. What happens when you don’t have enough free RAM and you want to continue to use your computer/tablet/phone? Virtual Memory! Your computing device carves out a small chunk of hard drive space and utilizes it like RAM. This is a very convenient, and historically affordable workaround. In years past, and in many cases today, permanent storage (hard drives, solid state drives), offer a much more affordable storage medium than RAM. The problem, especially 20 and 30 years ago, is that hard drives are much slower than RAM, a few orders of magnitude slower -anywhere from 1,000 to 10,000 times slower than RAM.
When you are done with the application or background service, the space it is occupying in RAM is freed up for the next time it is needed. When you turn off your computer (yes, a restart counts as turning off your computer) everything in RAM is lost. The next time your computer boots up, all of the RAM is free to be used as needed.
The analogy I use to describe RAM is to think of a road or interstate system that is used to transport goods between various locations. The more roads you have, the more you can transport at the same time. RAM works in a very similar way; the more RAM you have, the more you can do with your computer without lag or the computer feeling bogged down.
Desktop memory (the two longest sticks) and laptop memory (the shorter stick).
Permanent Storage:
RAM holds all of the data that is “live” or is being used currently. Hard Disk Drives and Solid State Drives are permanent storage devices that hold your files until you decide to delete them (or the device fails). If you look at the graphic below, you will notice that hard disk drives are similar to a record player. There is a flat disk that has data and there is an arm with a needle at the end that reads and writes the data on the surface. If you look closely, you will see there are multiple flat disks sitting on top of each other on a spindle and the arm you see is not just one arm, but one arm for each for the top and bottom of each disk/platter in the spindle. The arms all move together and the data that you write to the hard drive is spread across multiple disks/platters.
Solid state drives have no physical moving parts and made up of many banks of memory chips (similar to RAM) that retain the information after the drive loses power, something that RAM chips do not do. They also tend to use much less electricity and produce less heat. If you have ever used a USB Flash Drive to move files around, you have already used a type of solid state drive, just very slow and somewhat clunky. Smart phones use a similar type of flash memory as their permanent storage device.
The great part about hard drives is that you can get a lot of storage capacity for not a lot of dollars. The largest capacity drive (as of this writing) is 10TB. The downside is that they have a relatively high failure rate compared to solid state drives and are considerably slower. In my many years of experience working for universities or customers I have found that the most common component to fail in any given system is the hard drive. You will notice that many new computers still use hard drives because most users are more interested in the amount of data they can store on their computer and the price they are paying for that computer. A good 1TB laptop hard drive can be purchased for $70-$90 depending on the market conditions. A 1TB solid state drive can be purchased for $400-$500 depending on market conditions.
The graphics/video card in your device works with the operating system and applications to create the video you see on your display. For high-end systems that are built to play high-end video games, edit video, or create high-end content for games or video, there are hundreds of options for video cards ranging from thirty dollars to thousands of dollars. These cards, in many ways, are like small computers themselves. They have GPUs (graphics processing units), memory, high-speed data buses, etc.
Many modern computers have the graphics/video card integrated into the motherboard. This saves money on buying more components to plug into the motherboard, frees up space in the case, produces less heat, and is more convenient for device manufacturers. The downside to having an integrated video card is that some of the work is offloaded to the CPU and can cause slower performance in very high-demand video applications. The good news is that almost all integrated video cards for the last 5 years have been able to have flawless playback of high definition videos. For the vast majority of computer users there is rarely a need to have a discrete graphics card added to the system. One thing that you should know if you are buying a laptop: you can almost never add a graphics card to a laptop. If you want to have a discrete graphics card in your laptop, make sure it has one when you buy it; there is no upgrading that component in the future.
One of the biggest parts of my job when working with clients is correcting misinformation. Here is part of an email I received from a client last month:
We stopped at Walmart last night and one of their people suggested we use a laptop as a processor because he thought there were better deals on them at the present time. He said they had better processors for less price than a desktop. She would still keep and use her present monitor and keyboard. Does that make sense to you or not?
Let me start by saying that I have no problems with people that work at Wal-Mart, K-Mart, Best Buy, or any other retailer. I have no interest in insulting anyone’s intelligence or abilities. However; very few retailers offer training beyond “Hi, my name is John, how can I help you?” and “The restrooms are at the front and rear of the store.” Also, you have no idea if the person working in the electronics department actually has any interest in the items for sale in the electronics department. While I am sure they are great at sending those fancy text messages with emojis, do they have any real interest in understanding the technology behind the toys?
How did I respond to the email? “No, that person has absolutely no idea what they are talking about. Don’t ever take computer buying advice from that person again. Desktops offer faster processing, more memory, more storage, and on average last longer as there is less of a heat issue.”
Here is another message I received:
We were looking at the new Apple TV devices at Wal-Mart and the guy at the counter told us that the three current models have 64GB of storage ($199), 32GB ($149) and 16GB ($69) - just like the phones. Which would you recommend?
I don’t know if this was the same employee the first client had talked with, but based on the lack of accurate knowledge, I wouldn’t be surprised. There are currently two generations of Apple TV devices. The fourth generation is the latest and greatest that Apple has to offer in streaming devices and it allows you to install applications through an app store, just like you can on iOS or Android devices. The fourth generation is available with two different storage options, 32 and 64GB. The third generation Apple TV, which has been on the market for 3 years, does not allow you to install applications and you are stuck with the apps that Apple wants you to have for this model, which is still a pretty good selection.
I don’t write these stories to bash the employees at your local retailer. It is my intent to demonstrate that you need to find someone you can trust to give you recommendations and advice about your technology needs. I have no doubt there are some employees at some stores that have a serious interest in the electronics department they are working in; but I would suspect that the vast majority would not be able to give you the same level of knowledge and experience that someone that works in technology could provide.
I work in technology. I work at a university during the day. When I am not working at the university, I work with clients; some are local businesses that are not large enough to have a full-time technician, many are local residents that need help with technology in their homes. My customers are almost always technologically inexperienced and one of my strong suits is breaking down high-level technological concepts and explaining it in ways that my customers understand.
I am creating this blog for a few reasons:
I want to create content that readers will find easy to understand and increases their knowledge of technology while making it somewhat less of a scary monster
I am hoping this will increase my knowledge and experience – it is amazing how you can work in a field for so long and yet discover something knew when explaining or researching something that most people in the field consider common knowledge
I am hoping to strengthen my writing skills.
I will be creating a form that will allow readers to submit requests for topics to be covered.
I have disabled comments mostly for my convenience, but also to eliminate the spam comments about performance pills and links to websites that you don’t want to visit.
